003 SERIES PRESSURE UNLOADER
Maximum Operating Pressure — 1500 psi
Maximum Operating Temperature — 180°F
Maximum Flow Rate — 4 GPM
Design Considerations
The 003 Series Unloader is designed is for low pressure cold water pressure wash applications. The 003 Series Unloader traps pressure in the line when the spray gun is closed. The bypass port opens and fluid flows back to the inlet side of the pump or reservoir, allowing the pump to run under significantly reduced pressure. When the spray gun is opened, the bypass port closes and fluid is directed downstream to the nozzle. The 003 Unloader is tested for performance but not preset for pressure. Start with the Unloader at its lowest spring tension. Raise pressure by turning the adjusting cap clockwise. Fluoroelastomer (Viton®) Seals are available.
Options
| Material Options | Brass Body and Ends, Stainless Seat, Piston and Springs | ||
| Seal Options | Buna-N (Standard), Fluoroelastomer (Viton®) | ||
| Inlet End | 3/8 Male NPT | ||
| Outlet End | 3/8 Male NPT | ||
| Bypass End | 1/4 Female NPT | ||
| Springs Options | 500 psi, 1000 psi, 1500 psi All springs are adjustable from approximately 30% minus to 20% plus the spring rating. For example, a 500 psi spring can be set to operate in an adjustment range of 350 to 600 psi |
||
| Repair Kit Options |
|
Example of how to order
| Spring 1000 psi | Seal Buna-N |
SMC Part Number: UNLOADER, 1000 PSI
SMC Part Numbers are a description of the based on the spring rate and Seal Material
Example: UNLOADER 1000 PSI = 1000 psi Spring, Buna-N Seals
"Printer-Friendly" Version